This series of hand-cranked automatic wire arrangement machine adopts hand-cranked gear drive, pointer or electronic counting, mechanical control automatic wire arrangement. It can be used to wind all kinds of small coils with less number of turns and need automatic wiring.
FZ-160 type hand-cranked electronic counting and arranging machine
Power supply voltage 220V
Applicable wire diameter 0.06-0.50mm
Diameter of coil 12-150mm
Width of coil 6-110mm
Counting range 0-59999 turns
Transmission speed ratio fast 1:6; slow 1:1.5 two gears
Diameter of payoff frame shaft 10mm, width of bobbin 85mm, diameter of payoff bobbin 130mm;
Take-up shaft diameter 10mm.
Volume: 51*34*33cm
Carton package, weight 23KG or so
FZ-160 Automatic Wire Rowing Machine Specifications
Use: This machine is suitable for telecommunications, electrical industry manufacturing low-voltage transformers, automotive ignition coils, wire-wound resistors, meter parts, such as flat-wound and need to be lined up with a variety of coils can be applied.
Mechanical principle and method of use: This machine can be used by hand-cranked electric power, the host, the coarse wire tensioning device, the fixed position of the wire release frame should be 300mm apart, which is conducive to the coarse wire winding. Row around the coarse line with a handwheel on the shaft 35 teeth wheel rotating the middle 69 teeth wheel and then passed to the head shaft 23 teeth wheel, handwheel disk and the head shaft ratio of 1: 1.5, row line range of 20 # -30 #. Row winding fine line, with 69 teeth wheel on the handwheel axle to turn the center 35 teeth wheel and then pass to the head axle 23 teeth wheel, the handwheel disk and the head of the ratio of speed of about 1: 6, the range of row line 30 # -40 #.
Small friction disk on the handwheel axis, with rubber wheel vertical transmission of large Mocha disk and drive the long screw rotation. Rubber wheel for the yuan machine speed change mechanism. Twist the long screw knob to make the rubber wheel to shift and lead to the back of the drag plate to change speed. Twist the knob to adjust the density of the thread when changing the thread number.
Note that when moving the position of the rubber wheel, you must turn the handwheel, which makes the rubber wheel is not damaged, the rubber wheel part can not be refueled, keep clean, otherwise it affects the wiring, the wire from the barrel through the wire rod pulley over the cycle back to the drag plate on the two pulleys to the coil of the headstock shaft. Coil drive pulling wire, drag down the pendulum block, the line barrel can be free to release the line, once the wire interruption pendulum by the force of the tension spring will brake the disk, so that the line barrel is not inertia to continue to release the line. The travel of the coil length is controlled by the positioning ring.
Performance: Coil diameter 12-150mm, coil length 6-110mm. Applicable wire gauge SWG 20#-40# Countable turns 59999.
